Thingiverse
Super Basic Ender 3 Spool Holder Base
by Jo580rn3
5
Downloads
0
Likes
0
Makes
Needed a quick and dirty base for my ender 3 spool holder because I just installed my printer in a new enclosure and forgot to print a good one. The print shouldn't take more than an hour and a half.
My cura 4.6 settings are as follow:
Initial layer height: 0.2mm
Shells:
Optimize wall printing order on
Speed:
Print speed 58mm/s
Top surface speed: 20mm/s
My cura 4.6 settings are as follow:
Initial layer height: 0.2mm
Shells:
Optimize wall printing order on
Speed:
Print speed 58mm/s
Top surface speed: 20mm/s
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!