Thingiverse
Super thin Iris Case
von kyboon
1
Downloads
2
Likes
0
Makes
Warning: Very tight tolerance, measure before printing, and try the fit before soldering.
Top and bottom plates are 1.6mm thick. Inner space is 6.4mm tall. The whole case is 9.6mm tall (not accounting the switches and keycaps), it's the thinnest keyboard in my collection.
Designed for Iris rev.5 with choc switches.
20 M2 screws needed, anywhere between 4-7mm length would do.
Some rubber feet recommended to prevent the screws scratching your desk.
Top and bottom plates are 1.6mm thick. Inner space is 6.4mm tall. The whole case is 9.6mm tall (not accounting the switches and keycaps), it's the thinnest keyboard in my collection.
Designed for Iris rev.5 with choc switches.
20 M2 screws needed, anywhere between 4-7mm length would do.
Some rubber feet recommended to prevent the screws scratching your desk.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
