Thingiverse
Super thin Iris Case
by kyboon
1
Downloads
2
Likes
0
Makes
Warning: Very tight tolerance, measure before printing, and try the fit before soldering.
Top and bottom plates are 1.6mm thick. Inner space is 6.4mm tall. The whole case is 9.6mm tall (not accounting the switches and keycaps), it's the thinnest keyboard in my collection.
Designed for Iris rev.5 with choc switches.
20 M2 screws needed, anywhere between 4-7mm length would do.
Some rubber feet recommended to prevent the screws scratching your desk.
Top and bottom plates are 1.6mm thick. Inner space is 6.4mm tall. The whole case is 9.6mm tall (not accounting the switches and keycaps), it's the thinnest keyboard in my collection.
Designed for Iris rev.5 with choc switches.
20 M2 screws needed, anywhere between 4-7mm length would do.
Some rubber feet recommended to prevent the screws scratching your desk.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!