Support Storage Rack
by Wannespannes
0
Downloads
0
Likes
0
Makes
I bought myself some Storage Rack and Shelves to clean up my garage.
Unfortunately, the amount of metal supports was really to low as I had much more shelves then supports.
Although the original metal profile is much stronger then PLA , I tried if it was strong enough to hold old boxes, and it passed the test - it could hold my full weight.
The original version is not flat, so it was hard to print, so i removed the edges in version V2.
As this is my first design, I would love your feedback if you are planning to use it.
Unfortunately, the amount of metal supports was really to low as I had much more shelves then supports.
Although the original metal profile is much stronger then PLA , I tried if it was strong enough to hold old boxes, and it passed the test - it could hold my full weight.
The original version is not flat, so it was hard to print, so i removed the edges in version V2.
As this is my first design, I would love your feedback if you are planning to use it.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!