Support Storage Rack
von Wannespannes
0
Downloads
0
Likes
0
Makes
I bought myself some Storage Rack and Shelves to clean up my garage.
Unfortunately, the amount of metal supports was really to low as I had much more shelves then supports.
Although the original metal profile is much stronger then PLA , I tried if it was strong enough to hold old boxes, and it passed the test - it could hold my full weight.
The original version is not flat, so it was hard to print, so i removed the edges in version V2.
As this is my first design, I would love your feedback if you are planning to use it.
Unfortunately, the amount of metal supports was really to low as I had much more shelves then supports.
Although the original metal profile is much stronger then PLA , I tried if it was strong enough to hold old boxes, and it passed the test - it could hold my full weight.
The original version is not flat, so it was hard to print, so i removed the edges in version V2.
As this is my first design, I would love your feedback if you are planning to use it.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!