Support Test Example

**__Ko-Fi:__** [https://ko-fi.com/juliettaexpress](https://ko-fi.com/juliettaexpress)

---

Dead simple support test example, whipped up in about five minutes. Made mostly to test how slicers handle obvious overhangs, but may be useful as an actual printing test piece. Viewing from the bottom-up will show any support patterns to make for easy screenshots etc.

Customizer enabled for this one. If both "Rotate" and "Remove_Bottom_On_Rotate" are *both* set to true, one side vanishes to further make it obvious there's an overhang. Width STL has rotate set to false, Height STL has rotate set to true with "Remove_Bottom_On_Rotate" set to false, Height with Bottom STL has rotate and "Remove_Bottom_On_Rotate" both set to true, for reference (play with it, you'll see what I mean).

You could cheat and flip the model upside down and get a usable print with no supports, but... where's the fun in that? ;-)

---

### Changelog
**2018-09-07**
- Initial Upload