Thingiverse
Surface Mapping Tool
door Neophyte
23
Downloads
27
Likes
0
Makes
Not having access to any 3D scanning I decided to do some basic surface mapping the long and tedious way and came up with this tool to use as a template.
The grid holes are spaced 5mm x 10mm and each hole measures 1.1mm x 4.1mm which should allow a fairly snug fit for the "depth gauge shaft" of my Chinese made electronic digital caliper to pass through.
Yes, I'm fully aware that this will be a very time consuming method of mapping a surface but at least it will be reasonably effective.
[EDIT] I used this tool and a digital caliper to "map" the contour of the back of my HTC Desire HD phone so I could make a tri-pod mount for it - http://www.thingiverse.com/thing:8039
I just did one half and then mirrored the measurements for the other half.
The grid holes are spaced 5mm x 10mm and each hole measures 1.1mm x 4.1mm which should allow a fairly snug fit for the "depth gauge shaft" of my Chinese made electronic digital caliper to pass through.
Yes, I'm fully aware that this will be a very time consuming method of mapping a surface but at least it will be reasonably effective.
[EDIT] I used this tool and a digital caliper to "map" the contour of the back of my HTC Desire HD phone so I could make a tri-pod mount for it - http://www.thingiverse.com/thing:8039
I just did one half and then mirrored the measurements for the other half.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!