Thingiverse
Surface Pro Brace
von ddkaufman
1
Downloads
4
Likes
0
Makes
Made a few edits to the original design:
1. increased the screen lean-back angle just a bit (allows the kickstand to add extra support)
2. narrowed the screen clip a couple of mm so that it doesnt overlap the display screen
3. increased the gusset support a little larger (may not have been necessary - not sure)
4. trimmed back a few of the edges slightly to make it easier to put on
1. increased the screen lean-back angle just a bit (allows the kickstand to add extra support)
2. narrowed the screen clip a couple of mm so that it doesnt overlap the display screen
3. increased the gusset support a little larger (may not have been necessary - not sure)
4. trimmed back a few of the edges slightly to make it easier to put on
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!