Thingiverse
Switch Bracket
von sesso
2
Downloads
27
Likes
0
Makes
This is a bracket I made to use with a power switch to power off and on the prusa clone i have.
The hole dimensions are 18.8x12mm
I printed the above pics in .320 microns for show but the bracket I put in use was .200.
The hole dimensions are 18.8x12mm
I printed the above pics in .320 microns for show but the bracket I put in use was .200.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!