Thingiverse
Switch Pro Controller stand
von cpinkfloy4
2
Downloads
0
Likes
0
Makes
NO SUPPORTS!
a lot of the pro controller stand I've seen are super bulky, and are hard to print. this one makes it super simple, and super fast to print. mine only took about an hour to print. and only 22 g of filament
(print on its side)
a lot of the pro controller stand I've seen are super bulky, and are hard to print. this one makes it super simple, and super fast to print. mine only took about an hour to print. and only 22 g of filament
(print on its side)
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!