Sylvanian Large Balcony

Sylvanian (= Calico critters) large round balcony for Red Roof Cosy Cottage. Can be attached to the front of the cottage in replacement of the small barrier (Cottage ref. 5303) or small round balcony (Cottage ref. 5567), as shown on the picture.

Printed in 2 pieces with Anycubic Vyper
Sliced with Cura: Temp. 200°C / Draft 0.2mm / infill 20%
Using Gold Rosa3D PLA
No support needed

Print both the balcony floor and the guardrail (with pillars) upside down. Then insert the pillars in the holes of the balcony floor. Glue them for better fit. Depending on your printer tolerance, you might have to slightly enlarge the holes (with a 3mm Dremel engraving tool as I did or with a 3mm drill bit).
Depending on your printer tolerance, you might want to sand the attaching hook for smoother fit (I did not).