Sylvanian Small Balcony

Sylvanian (=Calico critters) small round balcony for Red Roof Cosy Cottage (ref. 5303 and 5567). Can be attached to the right "wall" in replacement of the small barrier, or directly to the ground of the first floor as shown on the picture.

Printed in 2 pieces with Anycubic Vyper
Sliced with Cura: Temp. 200°C / Draft 0.2mm / infill 20%
Using Gold Rosa3D PLA
No support needed

This balcony is an adaptation (Remix) from Nayb87 Simple Sylvanian Hook (https://www.thingiverse.com/thing:5335374).

Print both the balcony floor and the guardrail (with pillars) upside down. Then insert the pillars in the holes of the balcony floor. Glue them for better fit. Depending on your printer tolerance, you might have to slightly enlarge the holes (with a 3mm Dremel engraving tool as I did or with drill bit).