Thingiverse
Syringe Port Protector Cap
door GreyB0y
7
Downloads
7
Likes
0
Makes
This model is based on the "curos port protector cap" available in this link: https://www.amazon.com/Curos-Port-Protector-Caps-Green/dp/B00T5ACJNW/ref=sr_1_3?crid=A7R2HFZJ7ZL&keywords=caps+for+iv+line&qid=1647811830&sprefix=chlorhexidine+caps+for+IV,aps,63&sr=8-3
There's no screw function in this model.
There is two different iteratins of the same model, I had to tweak the design for printing in the machine I used but, in theory, both models should be printable.
DETECTED ERRORS: Due to the ammount of layers used in Fusion 360, some artifacts appear in the slicing software when slicing the model. To avoid this please follow the following instructions:
.- Print in the "Fine quality" or "high quality" option, selecting that on your slicing software.
.- Print with the fitting hole on the top.
.- Supports shouldn't be needed
.- Enable "Print thin walls" in your slicer.
There's no screw function in this model.
There is two different iteratins of the same model, I had to tweak the design for printing in the machine I used but, in theory, both models should be printable.
DETECTED ERRORS: Due to the ammount of layers used in Fusion 360, some artifacts appear in the slicing software when slicing the model. To avoid this please follow the following instructions:
.- Print in the "Fine quality" or "high quality" option, selecting that on your slicing software.
.- Print with the fitting hole on the top.
.- Supports shouldn't be needed
.- Enable "Print thin walls" in your slicer.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
