Thingiverse
Table top hinge
von Wiesolator
2
Downloads
2
Likes
0
Makes
A hinge that consists of the same part on both sides. It was designed for 25mm table tops and an 8mm steel shaft. You can print it directly without any supports. The gap dimensions are designed so that there is 0.5mm of space everywhere and there is no jamming.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!