Tank Level Sensor

23 October 2023
I made a more weather resistant lid. Use some silicon on the screws to better seal the top.

03 October 2022
I made some adjustments to fit a d1 mini. as well as a hole in the cover for an antenna. I haven't actually had a chance to print this yet to confirm the adjustments but will shortly.

23 August 2022
I made a small adjustment to a dimension on the body but it wasn't big enough to warrant it being V3

21 August 2022
Here is my first attempt at making my own home assistant sensor. This should thread onto any two inch diameter NPT bulkhead and read the fluid level distance from sensor. This was also designed in a way that the ultrasonic sensor is a press fit the esp32 is loose in case you need to access the boot button and no soldering is necessary. I am working on another version to make the esp32 more secure, a temperature sensor on the cover, possibly a status led on the cover, and a slot to pass wires though to pick up other sensors.

Parts:
1 - 3d