Taper Scraper

The Taper Scraper is to remove the tape off of the end of the roll when using Bambu Filaments. This has been an issue of late. Cross your fingers I may have figured out a solution! I hope! I have tested it a few times and it seems to work..... for the Non-AMS machines. I designed a little "Taper Scraper".... Bassacly it has a 2.0mm hole and is shaped like a wedge, you remove the PTFE lock from inside the machine move it to the outside of the machine, and pop the 3D Printed Taper Scraper on and Walla!! The wedge seems to scrape the tape off of the filament before it goes into the PTFE tube and recks your print, your machine, and your life.