Thingiverse
Temperature sensor support
von Dullamo
1
Downloads
1
Likes
0
Makes
This is a support I designed to hold a temperature/humidity sensor I bought off Amazon.
It is compatible with generic round shaped sensors.
This provides a 125 degrees inclination for easier readability.
It should be printed on the side as shown on the screenshots.
Print time ~2hrs
It is compatible with generic round shaped sensors.
This provides a 125 degrees inclination for easier readability.
It should be printed on the side as shown on the screenshots.
Print time ~2hrs
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!