TempTestV3 Temperature Tower Extreme - Hardcore Version

Since the usual temperature towers seemed to be to easy for my printer i did try to make a version that is way more challenging. But this [ https://www.thingiverse.com/thing:3366082 ] was still too simpel to see a real difference. So i stretched the bridging distance to 100mm, one with 5mm thikness and one with 1mm. Then i made two bows on one side, outer radius is 68 mm, one with 5mm and the other with 1mm, from 40 all the way to 90 degree, the notches are marking 10° each so you can see when it fails. After that i added a little "cliff" on the other side, the 30° angel should be easy enough for all printers, on this small plateau i build two structures, a cone with 5mm diameter and 15mm height, jut for basic precision, an how clean the incline is, next to it there is a helix with 3mm diameter, 2 mm rombus and 15mm height, also quite complicated, they are directly next to each other so stringing should also be visible. At leas i added to overhangs, again 1 and 5mm thickness and 50 mm