Thingiverse
Tensegrity
von Hamburgeraubacon
11
Downloads
11
Likes
0
Makes
Basic tensegrity structure.
The central wire support the top part mass while the 3 peripheral lines (in reality it's only one wire, see further) maintain the balance.
I made very narrow holes because I wanted to use a transparent fish rope instead of a thick cord as we can find on other thingiverse posts. That said, I tried a printing at 0.2 and it went good.
TIPS:
1- As it's really hard to knot the 3 lines with the same distance, I added gutters so it's possible to use only one long wire. With this, you only need 2 knots instead of 6.
Of course, the central wire is independant.
2- The central wire must be robust, it's the weakest part of the structure. I advice to use a strong knot on each side.
Enjoy!
The central wire support the top part mass while the 3 peripheral lines (in reality it's only one wire, see further) maintain the balance.
I made very narrow holes because I wanted to use a transparent fish rope instead of a thick cord as we can find on other thingiverse posts. That said, I tried a printing at 0.2 and it went good.
TIPS:
1- As it's really hard to knot the 3 lines with the same distance, I added gutters so it's possible to use only one long wire. With this, you only need 2 knots instead of 6.
Of course, the central wire is independant.
2- The central wire must be robust, it's the weakest part of the structure. I advice to use a strong knot on each side.
Enjoy!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
