Thingiverse
Tesla-Android Pi4 Case
von bernien
9
Downloads
5
Likes
0
Makes
Case design for Tesla-Android build using Pi4.
Top print remains the same for all three variants.
For Waveshare X630, use the 17mm standoffs and mount that come with the kit. In addition, use one 2.5x15mm standoff, 2.5mm nut, and whatever 2.5mm screws you have laying around.
For the C779, use the same top case, but swap out case bottom and print the mount for the C779 (I used the 17mm stand-offs from the X630 kit, but I think 15mm stand-offs are more common, so I may redesign that to work with 15mm stand-offs)
Argon Mini Fan is used, so there is no attachment point for top case in one corner.
The bottoms also have a variant in case you want to attach a CarlinKit CPC200-CCPA Dongle. Place the dongle in place before attaching the top and it should hold it in place. Still a work in progress. Feel free to comment if you want some changes made.
Top print remains the same for all three variants.
For Waveshare X630, use the 17mm standoffs and mount that come with the kit. In addition, use one 2.5x15mm standoff, 2.5mm nut, and whatever 2.5mm screws you have laying around.
For the C779, use the same top case, but swap out case bottom and print the mount for the C779 (I used the 17mm stand-offs from the X630 kit, but I think 15mm stand-offs are more common, so I may redesign that to work with 15mm stand-offs)
Argon Mini Fan is used, so there is no attachment point for top case in one corner.
The bottoms also have a variant in case you want to attach a CarlinKit CPC200-CCPA Dongle. Place the dongle in place before attaching the top and it should hold it in place. Still a work in progress. Feel free to comment if you want some changes made.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!