Thingiverse
Tevo_Endcap_Upperframe Version 2
von Coat
112
Downloads
61
Likes
2
Makes
Version 2 of the endcap for the upperframe of the Tevo Tornado.
With a Tevo-logo for some extra bling. For printers of other brands (CR10?) with same frame-material there is a version without logo.Or customize your own cap with that one.
From both there is a version with hard/sharp and soft edges.
Version two fits even better (PLA, room temperature), has a less thicker top and a geometrical correct logo (less sloppy, although you can hardly see it on this scale).
Also two extra types with a rounded surface and a sunken Tevo-logo. The second one is a little to much at my taste, but maybe you like it. The first extra is a nice one.
Due to the mountings at the corners at the underframe, it doesn't fit there. Look at https://www.thingiverse.com/thing:2879063 for caps that will fit at the underframe.
Fits like a charm (PLA, room temperature), press it until it clicks in.
I printed these caps with the logo up, no support needed.
Designed in Autodesk 123d
Sliced in Slic
With a Tevo-logo for some extra bling. For printers of other brands (CR10?) with same frame-material there is a version without logo.Or customize your own cap with that one.
From both there is a version with hard/sharp and soft edges.
Version two fits even better (PLA, room temperature), has a less thicker top and a geometrical correct logo (less sloppy, although you can hardly see it on this scale).
Also two extra types with a rounded surface and a sunken Tevo-logo. The second one is a little to much at my taste, but maybe you like it. The first extra is a nice one.
Due to the mountings at the corners at the underframe, it doesn't fit there. Look at https://www.thingiverse.com/thing:2879063 for caps that will fit at the underframe.
Fits like a charm (PLA, room temperature), press it until it clicks in.
I printed these caps with the logo up, no support needed.
Designed in Autodesk 123d
Sliced in Slic
Coat veröffentlicht auch auf
73 zusätzliche Modelle auf 1 weiteren Plattformen
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
