Tevo LED Lamp

LED Lamp to cast light on the print bed. Designed with 2 lamp "shades" to house 4 plastic channels for an LED strip to run through. The channels are super glued (aka Cyanoacrylate) to bottom of the the shade. One of my 4 channels printed slightly too tight for the LED strip so I suggest test fitting them to the strip before gluing in place.

Shades are designed to be held on with T-nuts / M4-10 screws but I found they could be press fit into the top 2020 rail. STLs are rotated as I printed them to minimize (but not get rid of entirely) the need for supports, brims should be used for the channel / switch parts to keep them in place.


Electrical:
I used a while LED strip from here: https://www.aliexpress.com/item/Free-Shipping-SMD5050-12V-flexible-light-60-leds-m-LED-strips-5m-lot-White-Blue-Green/1599651146.html?spm=a2g0s.9042311.0.0.iGPCJx and cut it to fit.

I initially tried to wire it into the PS for the printer but found that the LEDs would flicker with load change