Thingiverse
The Crazy Frog Rattle !
1
Downloads
10
Likes
0
Makes
🐸 The Crazy Frog Rattle (EN)
🎬 Short video: https://www.youtube.com/shorts/vkVDxaWS9eU
A fun little toy for a baby or young child!
⚠️ Please note: This is a 3D-printed object. Always check for sharp edges. If needed, smooth them out with a knife or a bit of sandpaper to make it safe and comfortable to touch. While it might be fine without post-processing, I strongly recommend doing it anyway. Only give it to your child if you believe it is safe and responsible to do so.
📺 Also check out my YouTube channel and support me by subscribing and possibly watching!
👉 youtube.com/@ElektroTechNL?sub_confirmation=1
🛠️ Print Instructions:
Print the rattle balls first.
While printing the rattle body, pause the print at layer 55 to insert the balls into the chamber. Then resume printing.
I used 4 balls, but you can add more or fewer depending on your preference.
⚙️ Print Settings:
Nozzle size: 0.4 mm
Layer height: 0.20 mm (standard profile)
Infill: 15% (or as desired)
Supports: Not requi
🎬 Short video: https://www.youtube.com/shorts/vkVDxaWS9eU
A fun little toy for a baby or young child!
⚠️ Please note: This is a 3D-printed object. Always check for sharp edges. If needed, smooth them out with a knife or a bit of sandpaper to make it safe and comfortable to touch. While it might be fine without post-processing, I strongly recommend doing it anyway. Only give it to your child if you believe it is safe and responsible to do so.
📺 Also check out my YouTube channel and support me by subscribing and possibly watching!
👉 youtube.com/@ElektroTechNL?sub_confirmation=1
🛠️ Print Instructions:
Print the rattle balls first.
While printing the rattle body, pause the print at layer 55 to insert the balls into the chamber. Then resume printing.
I used 4 balls, but you can add more or fewer depending on your preference.
⚙️ Print Settings:
Nozzle size: 0.4 mm
Layer height: 0.20 mm (standard profile)
Infill: 15% (or as desired)
Supports: Not requi
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!
