The Infinity Framework

Introducing the Infinity Framework! It's an Infinity Cube reduced to bare minimum! This is a spin-off from my Fidget Factory; check that out if you fancy designing your own fidgets. The print includes eight L-shaped pieces and eight hinges. Note there are two types of L-shapes, four of each one. Take care that you are connecting in the correct arrangement, as they are tricky to remove again. Look closely at the included photos first, and lay out the pieces correctly positioned before you start. Then simply fold the hinges to about 90 degrees and insert in to place between two of the L-shapes, then press them in and they click in to place. It is most easily done by pushing down on to a hard surface as shown below (this is a GIF, you may need to tap to play it): That's all, enjoy, and don't forget to come back and like, rate or even boost if you like it!