Thingiverse
ThingiBoat
por LewisSchool
6
Descargas
3
Likes
0
Makes
We made a tugboat. It goes to set #2. You take a rubber band put it between the two prongs and then you take the X and wind it towards the boat.
This model was designed during an after school 3D printing club by 5-7 graders.
This model was designed during an after school 3D printing club by 5-7 graders.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
