Thingiverse
ThingiBoat
von LewisSchool
6
Downloads
3
Likes
0
Makes
We made a tugboat. It goes to set #2. You take a rubber band put it between the two prongs and then you take the X and wind it towards the boat.
This model was designed during an after school 3D printing club by 5-7 graders.
This model was designed during an after school 3D printing club by 5-7 graders.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
