Thingiverse
Thread spool holder
von DreamKnights
2
Downloads
6
Likes
0
Makes
I took the original design and shrunk it down in Slic3r.
75% and printed 7sets at a time. = 5h:25m
50% and printed 15sets at once = 4h:43m
The Closet in my lab has unfinished walls so the space between studs is the perfect place to mount things without sacrificing space.
I super glued the units to the drywall. i didn't want screws sticking out of the face side of the drywall.
75% and printed 7sets at a time. = 5h:25m
50% and printed 15sets at once = 4h:43m
The Closet in my lab has unfinished walls so the space between studs is the perfect place to mount things without sacrificing space.
I super glued the units to the drywall. i didn't want screws sticking out of the face side of the drywall.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!