Thingiverse
Threaded insert installer/remover
por Make_Tech
0
Descargas
0
Likes
0
Makes
https://www.youtube.com/watch?v=we_GR11LYCA
This tool was developed to install "Nutserts" / "RivNuts" into 3D prints.
It requires:
1 Hex head m4 screw (preferably high tensile)
2 m4 grub screws
1 m8 grub scew
1 bearing 4mm I.D, 13mm O.D, 5mm wide
1 m4 washer
It works well to remove brass inserts if you want to upgrade to Nutserts, however it has limited cycle life if used to insert Nutserts. The thread will wear and bind up eventually.
This tool was developed to install "Nutserts" / "RivNuts" into 3D prints.
It requires:
1 Hex head m4 screw (preferably high tensile)
2 m4 grub screws
1 m8 grub scew
1 bearing 4mm I.D, 13mm O.D, 5mm wide
1 m4 washer
It works well to remove brass inserts if you want to upgrade to Nutserts, however it has limited cycle life if used to insert Nutserts. The thread will wear and bind up eventually.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!