Threaded Sphere Container

A simple threaded container perfect for holding small items and throwing in a backpack, or displaying as a desk container with the included stand! Spheres are challenging to print, so I spent many iterations tuning the design. I ended up with a model that uses only a few custom supports and prints easily. Simply press the four support sections inwards and they should break off cleanly. It may take a few cycles to break in the thread and make it smooth.    Print Settings .2mm layer height 2 walls 20% cubic infill no supports* Print the hemispheres open side down. *The flat “roof” on the inside uses bridging and usually comes out fine, but it may need supports for some printers. If your slicer is capable of adaptive layer height, this is a great model to use it on. It will produce a smoother and better looking top surface on each hemisphere.