Tight stringtest with Supportelement
von printaddict3d
0
Downloads
1
Likes
0
Makes
I needed a fast stringtest with a supportelement that was tighter than the ones i found here.
With this stringtest you can check if retractions between near objects and supports are working.
With low speed (25mm/s) the test takes under 20 Minutes.
With this stringtest you can check if retractions between near objects and supports are working.
With low speed (25mm/s) the test takes under 20 Minutes.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!