Tight stringtest with Supportelement
por printaddict3d
0
Descargas
1
Likes
0
Makes
I needed a fast stringtest with a supportelement that was tighter than the ones i found here.
With this stringtest you can check if retractions between near objects and supports are working.
With low speed (25mm/s) the test takes under 20 Minutes.
With this stringtest you can check if retractions between near objects and supports are working.
With low speed (25mm/s) the test takes under 20 Minutes.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!