Thingiverse
Tiny Amplifier
by AndyReact
0
Downloads
0
Likes
0
Makes
This is an enclosure that fits a TPA3118 60W (30W RMS) amplifier and looks a bit like an old Sony amplifier, the lid just sits on top, I melted it slightly on the edge with a lighter to hold it on.
Get the version of the amp without terminals on, there is no room for the cables to enter the terminals, they need to be soldered directly to the board.
I printed this in PLA, PETG would probably be better, but the amplifier doesn't appear to get hot.
Supports required.
Get the version of the amp without terminals on, there is no room for the cables to enter the terminals, they need to be soldered directly to the board.
I printed this in PLA, PETG would probably be better, but the amplifier doesn't appear to get hot.
Supports required.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!