Thingiverse
Tiny Amplifier
door AndyReact
0
Downloads
0
Likes
0
Makes
This is an enclosure that fits a TPA3118 60W (30W RMS) amplifier and looks a bit like an old Sony amplifier, the lid just sits on top, I melted it slightly on the edge with a lighter to hold it on.
Get the version of the amp without terminals on, there is no room for the cables to enter the terminals, they need to be soldered directly to the board.
I printed this in PLA, PETG would probably be better, but the amplifier doesn't appear to get hot.
Supports required.
Get the version of the amp without terminals on, there is no room for the cables to enter the terminals, they need to be soldered directly to the board.
I printed this in PLA, PETG would probably be better, but the amplifier doesn't appear to get hot.
Supports required.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!