Thingiverse
Tiny(-ish) Tri-Spinner
von drochte
3
Downloads
2
Likes
1
Makes
Center bearing is the MR74 (4mm ID x 7mm OD x 2mm H)
Ball Bearings are 12.7mm (1/2")
Buttons included
Tolerances were pretty tight for me, so some manual adjustment will most likely be necessary
I've included the .obj files for those who want to tinker
Inspired by https://www.thingiverse.com/thing:2123981
At the time, it was one of very few spinner designs not using a 608 for the center bearing
Ball Bearings are 12.7mm (1/2")
Buttons included
Tolerances were pretty tight for me, so some manual adjustment will most likely be necessary
I've included the .obj files for those who want to tinker
Inspired by https://www.thingiverse.com/thing:2123981
At the time, it was one of very few spinner designs not using a 608 for the center bearing
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!