Tiny Trainer HD conversion

I wanted to fit a Caddx Vista in my Tiny Trainer and didn't want to buy the conversion kit from five33 (Not that its expensive, but shipping was 4x more than the part). So I designed this up. Works perfectly fine for me!

The top plate I printed in carbon fiber nylon for strength. I haven't tested it with any other materials, so your results may vary. Print it with your strongest matterial.

I designed some TPU sheets to go under and ontop of your flight controller. This is mainly to isolate the delicate electronics from shorting out on the carbon fiber frame and the heatsinks on the caddx vista. You don't need these if you plan on isolating the board another way.

There are other camera mounts on here, but I wanted something I could adjust the angle on, I also decided to mount the Imortal T antenna for my crossfire RX under the camera, so there are holes to fit that in there. You'll need to bend the antenna in stupid ways to get it to fit, sorry!

The rear part holds an XT3