Toe Grab

I made this in Tinkercad, A quick search on Thingiverse didn't show any thing so I made this up. I hope it can help and be used during this epidemic. It may need some tinkering and the wall thinkness adjusted if it isn't strong enough I'd guess 20% or more in-fill. Should print just fine with zero supports. I'd imagine 3M, 15lbs double sided tape run generously across the back would suffice or some double sided tape as well as and gorilla glue or silicone and a 24 hour cure would be enough to adhere it to whatever door it is stuck too.. These could be used on any non-latching door that opens from the inside or outside at local businesses across our cities.