Thingiverse
TomTom Runner
von brucebar
3
Downloads
7
Likes
0
Makes
This is a watch cradle and straps for the TomTom Runner ( not 2 or 3, just Runner )
The watch strap for this watch is no longer available so if you still have one, you can use this to print a working strap to use your watch again.
I used a Zortrax M200 which is very accurate, so on different printers the watch may be a little tight or little loose.
The watch case must be printed on its side to improve strength - tested in ABS
The watch straps must be printed in flex or semi flex on their sides ( flat area standing up and the strap resting on the thin side ) so that it can fit into the slots on the cradle
This provides the most accurate printing of the wedge for the watch cradle
The clasp is designed to take the any old Garmin strap clasp
If you provide the TomTom clasp dimensions, i can upload a version for that
The watch strap for this watch is no longer available so if you still have one, you can use this to print a working strap to use your watch again.
I used a Zortrax M200 which is very accurate, so on different printers the watch may be a little tight or little loose.
The watch case must be printed on its side to improve strength - tested in ABS
The watch straps must be printed in flex or semi flex on their sides ( flat area standing up and the strap resting on the thin side ) so that it can fit into the slots on the cradle
This provides the most accurate printing of the wedge for the watch cradle
The clasp is designed to take the any old Garmin strap clasp
If you provide the TomTom clasp dimensions, i can upload a version for that
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
