Free Tools & Spare Parts STL Download - Tool Handleby ThudrickTheTinkerer

I created this to replace the handle on a hand weeding / grubbing tool. The original handle was wooden, and had rotted as I'd left it outside all winter.Honestly, I know it's a bit niche, but if you need one, you need one.It's designed to fit onto a 7.5mm shaft, you can probably scale the print to fit slightly different sizes. To fit it, I heated the shaft (don't be silly here, it doesn't need to be glowing) and pressed it into the hole in the handle. Following this, allow it to cool. Be patient, don't wiggle it or it'll end up loose!Print it on it's side, for strength. It will need support, probably don't put support in the hole or you'll have to clean it out.I printed mine in PLA, because that was in my printer at the time. In hindsight, red, or similar might have been a better choice, to make it easier to find in the lawn. PLA or PETG are probably reasonable choices for this, PLA softens at low temperature, so pressing the shaft in will be easier.