Thingiverse
Tool Setter
von Ramston
2
Downloads
0
Likes
0
Makes
This is a cheap tool setter that I made. It works using a micro limit switch in NC mode. It does the job pretty well.
the body part uses a 3MM threaded insert to join it to the base with 4 M3 screws.
Printed using Ultimaker Cura 5.7.1.
the body part uses a 3MM threaded insert to join it to the base with 4 M3 screws.
Printed using Ultimaker Cura 5.7.1.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!