Thingiverse
Touchlight
by Richy_T
4
Downloads
2
Likes
0
Makes
My flashlights keep evaporating. But I have a bunch of LEDs and some cr2032s around. These make handy quick flashlights but then the components end up all over the place so...
OK, you could do this with a couple of pieces of tape but gotta put that new printer to use.
The bottom groove for the led lead closed up so I think I need to make that bigger though it was still possible to jam the cell in there. The bridge needed some cleaning up too so I think giving that a little more clearance (or eliminating it all together) would not be a bad thing. I'd also like to find a way to lock the light on. A small loop to add a lanyard might not be a bad thing either.
OK, you could do this with a couple of pieces of tape but gotta put that new printer to use.
The bottom groove for the led lead closed up so I think I need to make that bigger though it was still possible to jam the cell in there. The bridge needed some cleaning up too so I think giving that a little more clearance (or eliminating it all together) would not be a bad thing. I'd also like to find a way to lock the light on. A small loop to add a lanyard might not be a bad thing either.
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!