Thingiverse
Transparency Test
por Raycekar
1
Descargas
0
Likes
0
Makes
This is the Transparency Test to test the transparency of your filament. I used this when creating a screen for my Hestiapi Thermostat out of filament that was too bright during the night. This was designed to be small enough to save on filament.
Each square is 5mm x 5mm and the height starts at 0.2 mm and goes up to 2mm in increments of 0.2mm.
Each square is 5mm x 5mm and the height starts at 0.2 mm and goes up to 2mm in increments of 0.2mm.
¿Has impreso este modelo? Inicia sesión y comparte tu make.
Inicia sesión para dejar un comentario
Iniciar sesiónAún no hay comentarios – ¡sé el primero!
