Thingiverse
Tree conductor
von ElCoBra
1
Downloads
2
Likes
0
Makes
For our new tree, I was looking for some rope to hold the tree to the pole. But then I realized it would be cooler to print some conductor...
I know it's printed in PLA and it's not very resistant to the weather, but I hope the tree will be strong enough when the conductor is failing ;-)
Designed with Fusion 360
Printed with CR10 0.1mm
I know it's printed in PLA and it's not very resistant to the weather, but I hope the tree will be strong enough when the conductor is failing ;-)
Designed with Fusion 360
Printed with CR10 0.1mm
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!