Thingiverse
Triangular rounded key
door m4rcSA
8
Downloads
4
Likes
0
Makes
We had a lamp post with the lid off. So I printed this key, after fixing it, to put in place again.
It's not a constant width polygon, so the sides didn't match. So I sketched over a reference photo with 2 arcs with FreeCad.
It perfectly fitted on first try. I have given 0,2 mm of extra margin on top of the height of the triangle. It's a modificable constraint of the sketch.
Prints fine without supports.
Dirt inside from using it in first photo.
It's not a constant width polygon, so the sides didn't match. So I sketched over a reference photo with 2 arcs with FreeCad.
It perfectly fitted on first try. I have given 0,2 mm of extra margin on top of the height of the triangle. It's a modificable constraint of the sketch.
Prints fine without supports.
Dirt inside from using it in first photo.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
