Thingiverse
Triangular rounded key
par m4rcSA
8
Téléchargements
4
Likes
0
Makes
We had a lamp post with the lid off. So I printed this key, after fixing it, to put in place again.
It's not a constant width polygon, so the sides didn't match. So I sketched over a reference photo with 2 arcs with FreeCad.
It perfectly fitted on first try. I have given 0,2 mm of extra margin on top of the height of the triangle. It's a modificable constraint of the sketch.
Prints fine without supports.
Dirt inside from using it in first photo.
It's not a constant width polygon, so the sides didn't match. So I sketched over a reference photo with 2 arcs with FreeCad.
It perfectly fitted on first try. I have given 0,2 mm of extra margin on top of the height of the triangle. It's a modificable constraint of the sketch.
Prints fine without supports.
Dirt inside from using it in first photo.
Vous avez imprimé ce modèle ? Connectez-vous et partagez votre make !
Connectez-vous pour laisser un commentaire
Se connecterPas encore de commentaires – soyez le premier !
