Triangular Stake with Mounts

The original stake was weak and broke on me a few days after putting it outside, as well I felt printing the stake horizontally would give more rigidity since the wind is blowing perpendicular to the layer lines. I designed this triangle stake from scratch and also made two additional mounting options for a side/hand rail on a porch.

I made the tolerances tight so depending on your printers accuracy you may need to heat the female socket to accept the male part. However starting the part and giving it a good push on a solid surface should get it set just fine.

The file - Triangle Stake Extension is the main mount and is what is used for the optional mounts.

There is a possibility that all these models will need to be "dropped" to the bed, for some reason the model got out of skew with the plane in fusion, though that should be fixed after I realigned all the bodies.

Supports should only be needed on the bodies not touching the bed, the female sockets do not need them.

Enjoy and T