Trimarans

This is a RC trimaran that I designed during the last weeks.
It has been designed to be printed on the elegoo jupiter, or any other big volume resin printer.
The electronics intended to be used are the following:
- 1 MG995 servo
- 1 sg90 servo
- 1 fs-IA6B receptor

It has been designed to use carbon rods (4 approx. 18 cm Ø 8 mm, 1 approx 45 mm Ø 8 mm and 1 100 mm Ø 12 mm).
The three middle parts should be assembled with M3 bolts, and silicon in between them. If you want it to go better, and if it isn't a problem to not being able to disassemble, you should use resin to make it smoother.

It should use around 2kg of resin in total

Note: I have currently not printed it, so I cannot ensure that it works properly.