Thingiverse
TrinityLabs Micro Extruder 1.0
by ezmobius
112
Downloads
171
Likes
1
Makes
This is the first 1.0 release of the new TrinityLabs micro direct drive extruder platform. This direct pinch extruder uses a small gear head stepper from eMinebea that is 56oz/in holding torque *before* the 30:1 delrin planetary gear head. So this little motor has way more then plenty of torque to direct drive 3mm or 1.75mm filament.
The motor is also so small it only weighs 118grams. And so this entire extruder including the motor, the extruder body, the idler, all vitamins, a 40mm fan and shroud and a Jhead hot end only weighs a grand total of 199grams. Compare this to 560grams for an average Wades or 790grams for a MakerGear plastruder and you can see that this little extruder can allow you to print very fast without the need for a bowden cable setup since the motor is so lightweight.
I have tested this extruder with 5 klilos of plastic and print quality is excellent all the way up to 200mm/sec and probably further even. It is even capable of lifting a MendelMax 3d printer off
The motor is also so small it only weighs 118grams. And so this entire extruder including the motor, the extruder body, the idler, all vitamins, a 40mm fan and shroud and a Jhead hot end only weighs a grand total of 199grams. Compare this to 560grams for an average Wades or 790grams for a MakerGear plastruder and you can see that this little extruder can allow you to print very fast without the need for a bowden cable setup since the motor is so lightweight.
I have tested this extruder with 5 klilos of plastic and print quality is excellent all the way up to 200mm/sec and probably further even. It is even capable of lifting a MendelMax 3d printer off
Did you print this model? Sign in and share your make!
Sign in to leave a comment
Sign inNo comments yet – be the first!