Thingiverse
Tuya Pir Motion Sensor Zigbee
von EchoNL
5
Downloads
7
Likes
0
Makes
I'm a beginner in making models with Fusion360.
I share the f360 files so you can remix them!
I made two models one 30 degrees and one 90 degrees angle. You can place them on you're desk or place them on you're wall / ceiling with sticky tape.
Happy printing!
I share the f360 files so you can remix them!
I made two models one 30 degrees and one 90 degrees angle. You can place them on you're desk or place them on you're wall / ceiling with sticky tape.
Happy printing!
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!