Thingiverse
TV Riser block
von kharmata
8
Downloads
10
Likes
0
Makes
This little block (well 4 of them actually) of PLA is/are currently holding my 55" LED TV 3" higher so I could fit my Center Speaker under it. :-D Cheers, be safe.
Thingiview not working but support is coned out in the middle.
Thingiview not working but support is coned out in the middle.
Hast du dieses Modell gedruckt? Einloggen und dein Make teilen!
Melde dich an, um einen Kommentar zu hinterlassen
AnmeldenNoch keine Kommentare – sei der Erste!
