MakerWorld
Electronics
Model downloaden
TV Riser
21
Downloads
3
Likes
6
Makes
I wanted to raise my up off the ground. I didnt want to spend a lot in filament so I tinkered with the size. I ended up at 175mm with a rectangle whole in the middle to save on filament. I wanted a way to test the pring before I put my TV on it so I stood on one foot on the print and it held me with no issue. As I weigh more than the TV I was confident it would hold. Print as many as you may need to feel comfortable rising your TV or monitor.
Heb je dit model geprint? Inloggen en deel je make!
Log in om een reactie achter te laten
InloggenNog geen reacties – wees de eerste!
